HOw do i make a poll?

[B E N Z]

How do you i make a poll?

Thanks in advance :)

[aznterrorist]

There is a check box at the bottom when you create the tread but other then that I can't help you.. :rice:

[turbo si]

Go to your favorite hardware store
Buy one steel plumbing pipe (for the pole) with threads on the bottom. It should be the height of your ceiling minus 5 inches and around 1 3/4 inches in diameter. They'll cut it for you at places like H. Depot. This will not be a shiny mirror color like some professional stripper poles.
Get a flange to screw the pole into. A flange is a strong base piece that you can screw the pole into and then bolt down to the bottom piece of wood.
Get the four nuts, bolts, and washers to attach the flange to the bottom of the stripper pole base.
Plywood usually comes in 4'x8', so get one of those and get them to cut it in half (again, they'll do that at H. Depot for you).
Get 12' worth of 2"x6" board. Cut it into two 4' pieces, one 1' piece, and two 1 1/2' pieces.
You'll want a drill with a bit the same size as the bolts for the flange.
Get some 2 1/2" nails or whatever you have lying around. You might also want a hammer or your brother's head.
If you want the pole to be more sturdy, get a bunch of bricks or flat-cinder-blocks to put in the base.

http://img7.imageshack.us/img7/3194/polefe9.th.gif (http://img7.imageshack.us/my.php?image=polefe9.gif)

http://img17.imageshack.us/img17/1983/diy3se2.th.jpg (http://img17.imageshack.us/my.php?image=diy3se2.jpg)

[Edison]

come over and you can smoke mine

[TRD Terror]

Go to your favorite hardware store
Buy one steel plumbing pipe (for the pole) with threads on the bottom. It should be the height of your ceiling minus 5 inches and around 1 3/4 inches in diameter. They'll cut it for you at places like H. Depot. This will not be a shiny mirror color like some professional stripper poles.
Get a flange to screw the pole into. A flange is a strong base piece that you can screw the pole into and then bolt down to the bottom piece of wood.
Get the four nuts, bolts, and washers to attach the flange to the bottom of the stripper pole base.
Plywood usually comes in 4'x8', so get one of those and get them to cut it in half (again, they'll do that at H. Depot for you).
Get 12' worth of 2"x6" board. Cut it into two 4' pieces, one 1' piece, and two 1 1/2' pieces.
You'll want a drill with a bit the same size as the bolts for the flange.
Get some 2 1/2" nails or whatever you have lying around. You might also want a hammer or your brother's head.
If you want the pole to be more sturdy, get a bunch of bricks or flat-cinder-blocks to put in the base.

http://img7.imageshack.us/img7/3194/polefe9.th.gif (http://img7.imageshack.us/my.php?image=polefe9.gif)

http://img17.imageshack.us/img17/1983/diy3se2.th.jpg (http://img17.imageshack.us/my.php?image=diy3se2.jpg)



This is how NOT to use it once installed
http://www.youtube.com/watch?v=jTjbKhn5QSU

[turbo si]

haha lmao