high compression D15d

[jdm_integra]

Hey i got this d15b for free it broke a timing belt and hit the valves,i want too re-place the valves with i have at home and shave the head and block as much as i can to make a high compression engine. Ill clay the engine as i go.

Does anybody see any problemes that i will have before i start.O and its just for my winter beater and my brother works in a machine shop so its just going to cost me the gaskets.

[HBoy]

Go for it. You can take quite a bit off on the d series (not familiar with the d15b though). Just make sure you engage the Vtec rocker when you clay.

You might be able to take .040"+ off (good for a full point or more).

Sure you want to run premium in your beater though?

[jdm_integra]

thanks man,i dont mind running super i dont do that much kms its just for fun,is it going to make a big diffrence?

[HBoy]

The general rule is about 4% per compression point.

[jdm_integra]

how many points do you i can get?cuz the ratio is at 9.6:1.

[HBoy]

2 points would (?) be the most depending on the valve/head clearances.